Midas XL8 DL431 Specifications download pdf (Page 29)

DL431 Mic Splitter

Operator Manual

Chapter 4: Getting Started

This section shows you how to connect up, switch on, set up and configure the DL431

Mic Splitter. For operating instructions, see Chapter 6 “Operation”.

Connecting up

Connect up your DL431 Mic Splitter as follows:

• Inputs - connect the inputs to the rear of the unit.

• Outputs - connect the A and B outputs to the rear of the unit.

• AES50 - connect the Ethernet cables from the routers to the AES50 audio - A and

AES50 audio - B X and Y sockets on rear of the unit.

• Ethernet - connect the Ethernet control cables to the rear of the unit.

• USB - connect a laptop/PC, if required, to the rear of the unit.

• Isolated C outputs - connect the isolated C outputs to the front of the unit.

• Mains power supply - insert the IEC connectors of the two mains cables into the

rear of the unit and then plug them both into mains power outlets.

Switching on/off

Caution!

When switching the unit on/off, press the two mains on/off

switches one after the other. Do not press them simultaneously.

After you have connected up your DL431 Mic Splitter it is ready to be switched on. To

do this, switch on both mains on/off switches on the rear of the unit, one after the

other. At the front of the unit, check that the LEDs in panels psu 1 and psu 2 are all

illuminated, see “psu 1 and psu 2 panels” on page 5.

To switch off the DL431 Mic Splitter, switch off the two mains on/off switches on the

rear of the unit, one after the other.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 79 80

No comments

Midas XL8 DL431 Specifications Page 29